posted
Oh,my god! It is so difficult to get the IP address of RTM and EmbeddedRTM node. The @status and @IP_parameter can not get the IP information. Could give me a demo or some advice. Maybe a demo is better. Thanks.
May send the demo to xxx@yyy.
[ 27.09.2011, 17:28: Message edited by AdAstra Technical Support ]
Posts 6 | From: China
| IP: IP address |
posted
Then,if the PC has a Ethernet port and wireless adpter.Then this PC has two IP address. 1.How to difine the IP Address of them Using the TM6 software? 2.The WinPAC-8000 has two Ethernet ports,one IP address is 192.168.1.194,another is 192.168.1.195. Then how to get the two IP Address in TM6?
Posts 6 | From: China
| IP: IP address |
posted
IP-addresses of all network adapters on the PC, you can see in the profiler protocol. It is located in the folder of the project node. To do this in your project node you want to create cnf-file. In the file you want to set the key "DEBUG=400". Technique for creating cnf-file is described in the help system.
Posts 82 | From: Russia
| IP: IP address |
Printer-friendly view of this topic
